,
Cause: The saw blade is inclined to cut; the water on both sides is different, and the water on one side is insufficient.
Solution: Check the inclination of saw blade; Check the cooling water system.
2. Wear at the joint of matrix and tool segment
Reason: The material being cut is very wear-resistant, and the cutting debris can not be discharged in the cutting seam.
Solution: The use of protective teeth in the special position of the matrix and the use of cooling water with larger pressure can enhance the chip removal effect.
Cause: Axis wear leads to large clearance between center hole and spindle of saw blade or incorrect installation.
Solution: Replace worn axles or repair central holes.
Reasons: Inclusion of material debris in the cutting seam causes uneven force on the body; too small flange diameter or inconsistent flange diameter on both sides; foreign inclusions between saw blade and flange; incorrect installation.
Solution: Clean up debris and enhance debris removal effect; adjust or replace flange; install correctly according to instructions.
5. Damage of diamond segment
6. Reasons: The blade binder is too hard; the feed speed of the saw blade is too fast.
Solution: Choose saw blade with softer binder according to the cut material, and reduce the feed speed of saw blade.
Copyright © boreway.com
Home |
About Us |
Products |
Quality Control |
News |
FAQ |
Contact Us |
Site Map