,
Reason:
During the cutting process, the material to be cut slides to twist off the cutter head;
Causing the cutter head to be hit hard;
The wear of the flange plate cannot fix the saw blade, resulting in the distortion of the saw blade;
overheated; The saw blade was violently impacted.
Resolvent:
Firmly fix the material to be cut during cutting;
Replace the flange plates on both sides;
Replace the worn main shaft;
Check the cooling water;
3. Blunt and unable to cut
Reason:
The bonding agent of saw blade is too hard;
Insufficient power can not make the saw blade cut normally, and the saw blade is not applied with enough cutting pressure;
The saw blade linear speed is too high.
Terms of settlement:
Select saw blade with softer binding agent;
Check the drive belt, voltage and motor;
Determining that a sufficient and not too large cut in pressure is used;
According to the instructions of the equipment, select the corresponding equipment.
4. Blunt and unable to cut
Reason:
Saw blade bonding agent is too hard;
Insufficient power cannot make the saw blade cut normally, and the saw blade is not applied with sufficient cutting pressure;
The line speed of the saw blade is too high.
Solution:
Choose a saw blade with a softer bonding agent;
Check the drive belt, voltage and motor;
Make sure you use sufficient and not excessive cut-in pressure;
Select the corresponding one according to the equipment manual.
Copyright © boreway.com
Home |
About Us |
Products |
Quality Control |
News |
FAQ |
Contact Us |
Site Map