Causes and solutions of common problems in the use of saw blade？
Cause: the cut material is very wear-resistant, and the cutting debris can not be discharged in the cutting seam.
Solution: the use of protective teeth in the special position of the substrate, the use of a larger pressure of cooling water flow can enhance the chip removal effect.
Cause: the saw blade is inclined to cut; the water quantity on both sides is different, and the water quantity on one side is insufficient.
Solution: check the inclination of saw blade; check the cooling water system.
Cause: the gap between the center hole of saw blade and the main shaft is large or the installation is not correct due to the wear of the shaft.
Solution: replace the worn shaft or repair the center hole.
Copyright © boreway.com
Home |
About Us |
Products |
Quality Control |
News |
FAQ |
Contact Us |
Site Map