When the diamond circular saw blade is in use, generally the sawing is stable, the cutting effect will be better, and the service life will be longer. If the situation of sawing instability is found, for example, the vibration is relatively severe, how to deal with it? The following are some simple explanations about this problem.
1 .Sawing vibration caused by poor equipment
When we find that there is a serious vibration phenomenon when we use the diamond circular saw blade for sawing processing, we should check whether the equipment is in good condition at the first time. This problem is mostly caused by the equipment, or the saw blade is not installed correctly.
1). Vibration situation during sawing caused by axial serial motion of motor
2). If the fixture is not clamped or the material is too thin, special fixture can be used
3). The diamond circular saw blade is not installed correctly during installation, which leads to signs of loosening
4). It is a common sense problem that the saw blade does not correspond to the material being cut off or the model and specification of the equipment. The corresponding situation should be checked again and again when using it.
The above are the most common factors that cause the unstable cutting of the saw blade. According to different situations, adopt different methods to avoid, and operate strictly according to the instructions, before using, it is necessary to check whether the equipment is in good condition and clean and maintain regularly to improve the sawing efficiency.
2. The cutting vibration caused by the quality problem of diamond circular saw blade
There are several situations of this kind of problem. One is that it is not used according to the regulations, or the use time of the saw blade has come, and the other is that there are quality problems in the production of the diamond saw blade.
1). It is a natural phenomenon that the sawtooth becomes blunt, because the saw blade is a consumable and needs to be re-grinded or replaced after a certain period of use. When using, we should check the situation regularly to ensure the quality of cutting.
2). The angle is not right. There are many kinds of sawtooth. For different equipments and materials, different diamond circular saw blade milling cutters are needed, which are similar to the model and specification.
3). There is something wrong with the material of the saw blade. The most direct way to make this is to find the supplier, contact the supplier for replacement or refund, etc.
4). Another point is the material being cut off. If the concave-convex is very serious, it is inevitable that it will vibrate during sawing. In this case, it is generally necessary to reverse the material first and make it smooth, then conduct cutting processing.
No matter what kind of problem it is, the diamond segment of the diamond saw blade must ensure its sharpness. After installation, it must be idling for about 15 seconds to check whether it works properly before it can be used.
Copyright © boreway.com
Home |
About Us |
Products |
Quality Control |
News |
FAQ |
Contact Us |
Site Map
